2.4 Litre Create Motor Long Blocks comes with the following parts installed. This is a 2.4 block and will require 2.4 engine mounts when replacing a 2.0. Clevite 77 Rod Bearing Set

Clevite 77 Main Bearing Set

Total Seal Piston Rings

New Carter Water Pump

All gaskets and Seals

Melling Oil Pump

Eagle Specialty Forged Rods

JE Pistons in your choice of 8.6, 10.5 or 12.5 compression

16 Eaton PT Cruiser Lash Adjusters (Lifters)

16 PT Cruiser Cam Followers (Rockers)

Timing Belt

Complete Head Gasket Set

1 Pair of Crane DOHC Cams 193-0010, 193-0012, or 193-0014,193-0016 or 193-0018

1 Pair of AEM Adjustable Cam Gears

Crane Valve Springs and Retainers

set of stainless steel valves

Seasoned Block and head

Blocks are bored and honed with a deck plate to insure that the cylinder walls are true.

Crankshaft and rotating assembly are race balanced

Cylinder head; Smooth the casting, and blend the seats, full race port with reshaped ports, reshaped combustion chamber, and full port matching.

Cams are degreed for proper centerline All clearances are blue printed

When ordering your short block specify SOHC or DOHC, and specify compression ratio you desire.

Long blocks are shipped without valve cover and without oil pan and no timing cover

Shipped without exhaust manifold and intake manifold

These are race engines and are sold for racing purposes only. They are sold as is, with no warranty expressed or implied. Short blocks are shipped without cylinder heads or oil pans. Engine contains no oil. Proper break in of engine must be observed to insure long life. Inspect all bracket mounting holes before use. Engines are built to order, estimated build time could be serveral months before engine is complete and ready to ship. Blocks are shipped by Motor Freight from Keyser. Lift gate service to help in unloading is available at additional cost, but must be requested at the time of order. Engine must be signed for at time of delivery.